IIT-2000/2010/5000/5010 Instruction Manual/English
28 05/08/2015 Version No. 001
5. Ensure the earth ground of the line voltage is properly
grounded.
6. Ensure any devices that are adversely affected by magnetic
fields are not placed near the tester.
Operating Precautions
The IIT-2000/2010/5000/5010 is a high voltage instrument that
outputs dangerous voltages. The following section describes
precautions and procedures that must be followed to ensure
that the tester is operated in a safe manner.
The IIT-2000/2010/5000/5010 generates voltages of up to
5kVAC or 6kVDC. Follow all safety precautions, warnings and
directions given in the following section when using the
instrument.
1. Never touch the safety tester, lead wires, terminals, probes
and other connected equipment when the tester is testing.
2. Do not turn the safety tester on and off quickly or repeatedly.
When turning the power off, please allow a few moments
before turning the power back on. This will allow the protection
circuits to properly initialize.
To Next Page
Loading...
