RS PRO IIT-2000 - Setting PASS HOLD

IIT-2000/2010/5000/5010 Instruction Manual/English
62 05/08/2015 Version No. 001
Setting PASS HOLD
Background
The PASS HOLD settings only apply to the selected test in an
AUTO test. When the PASS HOLD setting is set to ON, a
PASS judgment is held until the START button is pressed.
Note
The PASS HOLD setting only applies to AUTO tests. This
setting is ignored when running a single MANU test.
Steps
1. Press the UTILITY key on the front panel when the
tester is in EDIT status. The display will go from the
normal EDIT status to the MANU Utility menu for the
current test .
UTILITY
L I T Y IM A UN U T 2M A N U = * * * - 0 0
A R C M D E : OO FF
G R O U N D MO D E : NO
P A S S H L D :O O FF
F A I L M D E :O
PS T O
M A X H O L D : O F F
Note
The MANU UTILITY settings only apply to the selected MANU
test.
2. Use the UP/DOWN arrow keys to move to the
PASS HOLD setting.
3. Use the scroll wheel to set PASS HOLD.