IIT-2000/2010/5000/5010 Instruction Manual/English
4 05/08/2015 Version No. 001
Frame or Chassis Terminal
Do not dispose electronic equipment as unsorted municipal
waste. Please use a separate collection facility or contact the
supplier from which this instrument was purchased.
Safety Guidelines
General
Guideline
CAUTION
Do not place any heavy object on the instrument.
Avoid severe impact or rough handling that leads to damaging
the instrument.
Do not discharge static electricity to the instrument.
Use only mating connectors, not bare wires, for the terminals.
Do not block the cooling fan opening.
Do not disassemble the IIT-2000/2010/5000/5010 unless you
are qualified.
(Measurement categories) EN 61010-1:2010 specifies the measurement
categories and their requirements as follows. The IIT-2000/2010/5000/5010 does
not fall under category II, III or IV.
Measurement category IV is for measurement performed at the source of low-
voltage installation.
Measurement category III is for measurement performed in the building
To Next Page
Loading...
