Configuration Guide System Upgrade and Maintenance
In the pop-up dialog box, select the file to download from the File Name field and Xmodem from the Protocol
field. Click “Send”, and the Windows HyperTerminal will show the transmission process and packets.
In the CLI command mode, upload the files by performing the following steps:
Prior to upload, first log in to the out-band management interface of the switch by using the Windows
HyperTerminal. Then, upload the files by using the following command in the privileged EXEC mode. Finally,
select the “Receive File” from the “Transfer” menu on the Windows HyperTerminal on the local host. It’s shown
in the following figure:
In the pop-up dialog box, select the storage location for the file to upload and select the “Xmodem” as the
reception protocol. Click “Receive”, and the Windows HyperTerminal will further prompt the name of the locally
stored file. Click “OK” to start reception. The operaton is shown below:
To Next Page
Loading...
