Ruijie RG-S2900G-E Series - Configuring Static Neighbor

Configuration Guide IPv6 Configuration
Mac Address: 00:d0:f8:00:00:01
INET6: fe80::2d0:f8ff:fe00:1 , subnet is fe80::/64
INET6: fec0:0:0:1::1 , subnet is fec0:0:0:1::/64
Joined group address(es):
ff01:1::1
ff02:1::1
ff02:1::2
ff02:1::1:ff00:1
MTU is 1500 bytes
ICMP error messages limited to one every 10 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 200 seconds<240--160>
ND router advertisements live for 1800 seconds
Configuring Static Neighbor
This section will describe how to configure a static neighbor. By default, the static
neighbor is not configured. In general, a neighbor learns and maintains its status by
the Neighbor Discovery Protocol (NDP) dynamically. Moreover, you can configure the
static neighbor manually.
To configure the static neighbor, execute the following commands in the global
configuration mode.
Command
Meaning
configure terminal
Enter the global configuration mode.
ipv6 neighbor ipv6-address interface-id
hardware-address
Configure a static neighbor on the interface.
end
Return to the privileged EXEC mode.
show ipv6 neighbors
View the neighbor list.
copy running-config startup-config
Save the configuration.
Use the no ipv6 neighbor command to delete the specified neighbor. The following is
an example to configure a static neighbor on SVI 1:
Ruijie(config)# ipv6 neighbor fec0:0:0:1::100 vlan 1 00d0.f811.1234
Ruijie (config)# end
Ruijie# show ipv6 neighbors verbose fec0:0:0:1::100
IPv6 Address Linklayer Addr Interface
fec0:0:0:1::100 00d0.f811.1234 vlan 1
State: REACH/H Age: - asked: 0