Configuration Guide Basic Switch Management Configuration
Configuring a System Name
Our products provide the following commands to configure a system name in
the global configuration mode:
Ruijie(Config)# hostname name
Configure a system name with printable
characters less than 255 bytes.
To restore the name to the default value, use the no hostname command in the
global configuration mode. The following example changes the equipment
name to RGOS:
Ruijie# configure terminal //Enter the global configuration mode.
Ruijie(config)# hostname RGOS //Set the equipment name to RGOS
RGOS(config)# //The name has been modified
successfully.
Configuring a Command Prompt
System name will be the default prompt if you have not configured command
prompt. (if the system name exceeds 32 characters, intercept the first 32
characters) The prompt varies with the system name.You can use the prompt
command to configure the command prompt in the global configuration mode,
and the command prompt is only valid in the EXEC mode.
Set the command prompt with printable
characters. If the name exceeds 32
characters, intercept the first 32 characters.
To restore the prompt to the default value, use the no prompt command in the
global configuration mode.
Banner Configuration
Overview
When the user logs in the switch, you may need to tell the user some useful
information by configuring a banner. There are two kinds of banners:
message-of-the-day (MOTD) and login banner. The MOTD is specific for all
users who connect with switches. And when users log in the switch, the
notification message will appear on the terminal. MOTD allows you send some
urgent messages (for example, the system is to be shut down) to network users.
The login banner also appears on all connected terminals. It provides some
common login messages. By default, the MOTD and login banner are not
configured.
To Next Page
Loading...
