Ruijie RG-S2900G-E Series - Configuration Procedure

Configuration Guide RADIUS Dynamic Authorization Extension Configuration
Configuration Procedure
1) Enable RADIUS authentication on the access authentication device (this example uses the 802.1x authentication
mode).
Ruijie# config
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# aaa new-model
Ruijie(config)# aaa authentication dot1x default group radius
Ruijie(config)# aaa accounting network default start-stop group radius
Ruijie(config)# dot1x authentication default
Ruijie(config)# dot1x accounting default
Ruijie(config)# radius-server host 192.168.181.66 key radius-key
Ruijie(config)# interface range fa0/2-3
Ruijie(config-if-range)# dot1x port-control auto
Ruijie(config-if-range)# exit
2) Enable RADIUS dynamic authorization extension.
Ruijie(config)# radius dynamic-authorization-extension enable
3) After the user logs in, the administrator uses RADIUS dynamic authorization extension on the SAM to log out the
user.
4) The user is logged out and needs to be authenticated again to access the network.