Ruijie RG-S2900G-E Series - Verifying the Configuration

Configuration Guide ERSPAN Configuration
Verifying the configuration
Step1: Display the configuration of the device.
! The configuration of the Switch A.
SwitchA#show running-config
!
monitor session 1 erspan-src
source interface GigabitEthernet 0/1 both
origin ip address 10.1.1.2
destination ip address 12.1.1.2
Step2: Display the ERSPAN information of the device.
! Display the Switch A.
SwitchA#show monitor
sess-num: 1 //ERSPAN Session
span-type: ERSPAN_SOURCE //ERSPAN Source device
src-intf: //ERSPAN Source port
information
GigabitEthernet 0/1 frame-type Both status: Active
dest-intf: //ERPSAN Output port information
GigabitEthernet 0/2
orgin ip address 10.1.1.2
destination ip address 12.1.1.2
ip ttl 64
ip dscp 0