Configuration Guide Basic Switch Management Configuration
Configuring a Message-of-the-Day
You can create a notification of single or multi-line messages that appears when
a user logs in the switch. To configure the message of the day, execute the
following commands in the global configuration mode:
Ruijie(Config)# banner motd c
message c
Specify the message of the day, with c
being the delimiter, for example, a pound
sign (&). After inputting the delimiter, press
the Enter key. Now, you can start to type
text. You need to input the delimiter and
then press Enter to complete the type. Note
that if you type additional characters after
the end delimiter, these characters will be
discarded by the system. Also note that you
cannot use the delimiter in the message
and the message length should be no more
than 255 bytes.
To delete the MOTD, use the no banner motd command in the global
configuration mode. The following example describes how to configure a MOTD.
The # symbol is used as the delimiter, and the text is “Notice: system will
shutdown on July 6th.”
Ruijie(config)# banner motd # //Start delimiter.
Enter TEXT message. End with the character '#'.
Notice: system will shutdown on July 6th.# //End delimiter.
Ruijie(config)#
Configuring a Login Banner
To configure a login banner, executing the following commands in the global
configuration mode:
To Next Page
Loading...
