Ruijie RG-S2900G-E Series - Rmon Configuration Task List

Configuration Guide RMON Configuration
Alarm
Alarm is the third group in RMON. It monitors a specific management
information base (MIB) object at the specified interval. When the value of this
MIB object is higher than the predefined upper limit or lower than the predefined
lower limit, an alarm will be triggered. The alarm is handled as an event by
means of recording the log or sending the SNMP Trap message.
Event
Event is the ninth group in RMON. It determines to generate a log entry or a
SNMP Trap message when an event is generated due to alarms.
RMON Configuration Task List
Configuring Statistics
One of these commands can be used to add a statistic entry.
Command
Function
Ruijie(config-if)# rmon collection stats
index [owner ownername]
Add a statistic entry.
Ruijie(config-if)# no rmon collection
stats index
Remove a statistic entry.
Caution
The current version of Ruijie product supports only the statistics
of Ethernet interface. The index value should be an integer
between 1 to 65535. At present, at most 100 statistic entries can
be configured at the same time.
Configuring History
One of these commands can be used to add a history entry.
Command
Function
Ruijie(config-if)# rmon collection
history index [owner ownername]
[buckets bucket-number] [interval
seconds]
Add a history entry.
Ruijie(config-if)# no rmon collection
history index
Remove a history entry.