Configuration Guide Command Line Interface Configuration
dhcp IP Address via DHCP
Ruijie(config-if)#ip address
Here lists the parameter information after the command “ip address”, and replaces the alias
with the actual command.
An alias must be inputted fully for use. Otherwise, it can not be identified.
Use the show aliases command to view the setting of aliases in the system.
Accessing CLI
Before using CLI, you need to use a terminal or PC to connect with the network device. Power
on the network device. After the initialization of hardware and software, you can use CLI. If the
network device is used for the first time, you can only connect the network device through the
serial port (Console), which is referred to as out-band management. In addition, you can
connect and manage the network device through Telnet virtual terminal by performing
corresponding configuraitons. In either case, you can access the command line interface.
To Next Page
Loading...
