Configuration Guide 802.1x Configuration
Viewing the Radius Authentication and Accounting Configuration
Run the show radius server command to check the related configuration of the Radius Sever, and run the show aaa
user command to view the user-related information.
Ruijie# show radius server
Server IP: 192.168.5.11
Accounting Port: 1813
Authen Port: 1812
Server State: Ready
Viewing the Number of Current Users
Our 802.1X allows you to view the numbers of two types of users: one is the number of current users, and the other is that
of the authorized users. The number of current users refers to the total number of users authenticated (whether
successfully or unsuccessfully), while the number of authorized users means the total number of users authorized.
In the privileged EXEC mode, run the show dot1x command to check the current number of users and authenticated
users, 1x configuration, including the current number of users and authenticated users.
The following example shows the 802.1x configuration:
Ruijie# show dot1x
802.1X Status: Disabled
Authentication Mode: EAP-MD5
Authed User Number: 0
Re-authen Enabled: Disabled
Re-authen Period: 3600 sec
Quiet Timer Period: 10 sec
Tx Timer Period: 3 sec
Supplicant Timeout: 3 sec
Server Timeout: 5 sec
Re-authen Max: 3 times
Maximum Request: 3 times
Filter Non-RG Supp: Disabled
Client Oline Probe: Disabled
Eapol Tag Enable: Disabled
Authorization Mode: Disabled
MAC Move Permit: Enabled
Viewing the Authenticable Address Table
Our 802.1x has expanded functions that allow you to set the hosts that can be authenticated on a particular port. This
function allows the administrator to view the currently available settings.
In the privileged EXEC mode, you can view the list of hosts authenticable by performing the following steps:
To Next Page
Loading...
