Ruijie RG-S2900G-E Series - Ipv6 Monitoring and Maintenance

Configuration Guide IPv6 Configuration
Command
Meaning
copy running-config startup-config
(Optional) Save the configuration.
The no command of above commands can be used to restore the default value. For
details, refer to IPv6 Command Reference.
IPv6 Monitoring and Maintenance
It is mainly used to provide related command to show some internal information of the
IPv6 protocol, such as the ipv6 information, the neighbor table and the route table
information of the interface.
Command
Meaning
Show ipv6 interface [interface-id]
[ra-info]
Show the IPv6 information of the interface.
Show ipv6 neighbors [verbose]
[interface-id] [ipv6-address]
Show the neighbor information.
Show ipv6 route [static] [local]
[connected]
Show the information of the IPv6 routing table.
1. View the IPv6 information of an interface.
Ruijie# show ipv6 interface
interface vlan 1 is Down, ifindex: 2001
address(es):
Mac Address: 00:d0:f8:00:00:01
INET6: fe80::2d0:f8ff:fe00:1 , subnet is fe80::/64
INET6: fec0:1:1:1::1 , subnet is fec0:1:1:1::/64
Joined group address(es):
ff01:1::1
ff02:1::1
ff02:1::2
ff02:1::1:ff00:1
MTU is 1500 bytes
ICMP error messages limited to one every 10 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 200 seconds<240--160>
ND router advertisements live for 1800 seconds