Configuration Guide IPv6 Configuration
ipv6 nd reachable-time milliseconds
(Optional) Define the time when the neighbor is
considered to be reachable.
Note: as specified in RFC4861, the reachable time
of a neighbor should be increased or decreased at
random on the basis of the configured time in the
range of 0.5 to 1.5 of the configured time.
ipv6 nd prefix ipv6-prefix/prefix-length |
default [[valid-lifetime preferred-lifetime]
| [at valid-date preferred-date] | infinite |
no-advertise]]
(Optional) Set the address prefix to be advertised in
the router advertisement (RA) message.
ipv6 nd ra-lifetime seconds
(Optional) Set the TTL of the router in the router
advertisement (RA) message, namely the time as
the default router. 0, indicates that the router will not
act as the default router of the direct-connected
network.
ipv6 nd ra-interval seconds
(Optional) Set the time interval for the router to
send the router advertisement (RA) message
periodically.
ipv6 nd managed-config-flag
(Optional) Set the “managed address configuration”
flag bit of the router advertisement (RA) message,
and determine whether the host will use the stateful
auto-configuration to obtain the address when it
receives this router advertisement (RA).
ipv6 nd other-config-flag
(Optional) Set the “other stateful configuration” flag
bit of the router advertisement (RA) message, and
determine whether the host will use the stateful
auto-configuration to obtain other information other
than the address when it receives this router
advertisement (RA).
(Optional) Set whether suppress the router
advertisement (RA) message in this interface.
Return to the privileged EXEC mode.
show ipv6 interface [interface-id]
[ra-info]
Show the ipv6 interface of the interface or the
information of RA sent by this interface.
To Next Page
Loading...
