EasyManua.ls Logo

Ruijie RG-S2900G-E Series - Page 352

Ruijie RG-S2900G-E Series
943 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuration Guide IPv6 Configuration
Ruijie# show ipv6 interface vlan 1
Ruijie(config)# interface vlan 1
Ruijie(config-if)# ipv6 nd dad attempts 3
Ruijie(config-if)# end
Ruijie# show ipv6 interface vlan 1
Interface vlan 1 is Up, ifindex: 2001
address(es):
Mac Address: 00:d0:f8:00:00:01
INET6: fe80::2d0:f8ff:fe00:1 , subnet is fe80::/64
INET6: fec0:0:0:1::1 , subnet is fec0:0:0:1::/64
Joined group address(es):
ff01:1::1
ff02:1::1
ff02:1::2
ff02:1::1:ff00:1
MTU is 1500 bytes
ICMP error messages limited to one every 10 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 3
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 200 seconds<240--160>
ND router advertisements live for 1800 seconds
Configuring Other Interface Parameters
The IPv6 parameters on an interface fall into 2 parts, one is used to control the
behavior of the router itself, the other is used to control the contents of the router
advertisement (RA) sent by the router to determine what action should be taken by the
host when it receives this router advertisement (RA).
The following will introduce these commands one by one:
Command
Meaning
configure terminal
Enter the global configuration mode.
interface interface-id
Enter the interface configuration mode.
ipv6 enable
Enable the IPv6 function.
ipv6 nd ns-interval milliseconds
(Optional) Define the retransmission interval of the
neighbor solicitation message.

Table of Contents

Related product manuals