Ruijie RG-S2900G-E Series - Network Requirements

Configuration Guide DHCPv6 Relay Agent Configuration
The following example shows the DHCPv6 Relay destination address:
Ruijie# show ipv6 dhcp relay destination all
Interface: Vlan1
Destination address(es) Output Interface
3001::2
FF02::1:2 Vlan2
The following example shows the DHCPv6 Relay Agent statistical information:
Ruijie# show ipv6 dhcp relay statistics
Packets dropped : 2
Error : 2
Excess of rate limit : 0
Packets received : 28
SOLICIT : 0
REQUEST : 0
CONFIRM : 0
RENEW : 0
REBIND : 0
RELEASE : 0
DECLINE : 0
INFORMATION-REQUEST : 14
RELAY-FORWARD : 0
RELAY-REPLY : 14
Packets sent : 16
ADVERTISE : 0
RECONFIGURE : 0
REPLY : 8
RELAY-FORWARD : 8
RELAY-REPLY : 0
Typical Configuration Example of DHCPv6 Relay Agent
Network Requirements
1. Enable DHCPv6 Relay Agent on the Device1 and configure the destination address
3001::2;
2. Enable DHCPv6 Relay Agent on the Device2, configure the destination multicast
address FF02::1:2 for all Server and Relay Agent, and specify the destination
address for the outgoing L3 interface gi0/1.