Configuration Guide Basic Switch Management Configuration
Ruijie# reload in mmm
[reload-reason]
Configure the system reload in mmm
minutes, where the reload reason is
described in reload-reason (if inputted)
Ruijie# reload in hhh:mm
[reload-reason]
Configure the system reload in hhh hours
and mm minutes, where the reload reason
is described in reload-reason (if inputted)
The following example shows how to reload the system in 125 minutes
(assumes that the current system time is 12:00 a.m. January 10, 2005):
Ruijie# reload in 125 test //Set the system reload time
Or
Ruijie# reload in 2:5 test //Set the system reload time
Ruijie# show reload //Confirm whether the restart time change
takes effect
Reload scheduled System will reload in 2 hours and 4 minutes7485 seconds.
Immediate Restart
The reload command without any parameters will restart the device
immediately. In the privileged mode, the user can restart the system
immediately by typing the reload command.
Deleting the Configured Restart Scheme
In the privileged mode, use the following command to delete the configured
restart scheme:
Delete the configured restart scheme.
If no reload scheme is configured, you will see an error message for the
operation.
Configuring a System Name and Prompt
Overview
For easy management, you can configure a system name for the switch to
identify it. If you configure a system name of more than 32 characters, the first
32 characters are used as the system prompt. The prompt varies with the
system name. By default, the system name and command prompt is “Ruijie”.
To Next Page
Loading...
