Ruijie RG-S2900G-E Series User Manual

Configuration Guide Network Communication Detection Tools
Ping IPv6 Connectivity Test
To test the connectivity of a network, many network devices support the Echo
protocol. The protocol sends a special packet to a specified network address
and waits for a response. This allows you to evaluate the connectivity, delay
and reliability of a network. The ping tool provided by RGOS can effectively help
users diagnose and locate the connectivity problems in a network.
The Ping ipv6 command runs in the user EXEC mode and privileged EXEC
mode. In the user EXEC mode, only basic ping IPv6 functions are available.
However, in the privileged EXEC mode, extended ping IPv6 functions are
available.
Command
Function
Ruijie# ping ipv6 [address [length length]
[ntimes times] [data data][ source source]
[timeout seconds]]
Test the network connectivity.
The basic ping function can be performed in either the user EXEC mode or the
privileged EXEC mode. By default, this command sends five 100-byte packets
to the specified IP address. If the system receives a response within the
specified time (2 seconds by default), it shows "!" . Otherwise, it shows ".". If the
response does not match the request, the system shows “C” and outputs
statistics. This is a normal ping example:
Ruijie# ping ipv6 2000::1
Sending 5, 100-byte ICMP Echoes to 2000::1, timeout is 2 seconds:
< press Ctrl+C to break >
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/10 ms
The extended ping function can be performed in the privileged EXEC mode only.
This function allows you specify the number of packets, packet length, and
timeout. As with the basic ping function, the extended ping also shows statistics.
The following is an example of the extended ping:
Ruijie# ping ipv6 2000::1 length 1500 ntimes 100 data ffff source 2000::2
timeout 3
Sending 100, 1000-byte ICMP Echoes to 2000::1, timeout is 3 seconds:
< press Ctrl+C to break >
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!
Success rate is 100 percent (100/100), round-trip min/avg/max = 2/2/3 ms
Traceroute Connectivity Test
The Traceroute command is mainly used to check the network connectivity. It
shows all the gateways that a packet passes through from the source to the
destination and exactly locates the fault when the network fails.

Ruijie RG-S2900G-E Series Specifications

General

Brand	Ruijie
Model	RG-S2900G-E Series
Category	Switch
Language	English