Configuration Guide RLDP Configuration
command to restart the RLDP on the shutdown port. This command sometimes may make the
other ports with detection errors resume.
In the privileged mode, follow these steps to resume the RLDP detection of the port:
Make any port with RLDP detection failure resume
the detection.
The errdisable recover command can be used in the global configuration
mode to restart, instantly or at fixed time, the RLDP detection of the port that
is set violation by RLDP. It is worth mentioning that when there are some
relay devices between rldp ports, if you use errdisable recover interval to
restore the fault timely, you need to set the value of rldp detection time
greater than that of errdisable recover interval, that is, the value of
detect-interval* detect-max total time is greater than that of errdisable
recover interval to prevent error judgment.
Viewing RLDP Information
Viewing the RLDP Status of All Ports
In the privileged mode, run the following commands to view the RLDP global configuration and
the port detection information with RLDP detection configured:
View the RLDP global configuration and the port
detection information with RLDP detection
configured
In the example below, the show rldp command is used to view the detection information of all
RLDP ports:
Ruijie# show rldp
rldp state : enable
rldp hello interval : 2
rldp max hello : 3
rldp local bridge : 00d0.f8a6.0134
------------------------------------------------
interface GigabitEthernet 0/1
port state:normal
neighbor bridge : 00d0.f800.41b0
neighbor port : GigabitEthernet 0/2
unidirection detect information:
action : shutdown svi
state : normal
interface GigabitEthernet 0/24
port state:error
To Next Page
Loading...
