Configuration Guide FTP Client Configuration
Introduction to FTP Client
Instead of any standard FTP client using interactive commands, Ruijie FTP Client uses the copy command to complete
the steps of open, user and pass. After control connection is established, it will enter file transfer process and establish
data connection, allowing file upload or download.
Our former products support TFTP, yet TFTP is only used for the transfer of small files. FTP protocol
supports the transfer of large files. Implementing FTP allows the file transfer between local device and remote client
and server.
Configuring FTP Client
Configuring Connection Mode
The default connection mode is passive (PASV) mode. To configure the device to use active mode, execute the following
command in global configuration mode:
Enter global configuration mode
ftp-client [vrf vrfname] port
Configure FTP to use active connection mode
To configure the device to use passive mode, execute the following command in global configuration mode:
Enter global configuration mode
no ftp-client [vrf vrfname] port
Configure FTP to use passive connection
mode
Configuring Transfer Mode
The default transfer mode is BINARY mode. To configure the device to use ASCII mode, execute the following command
in global configuration mode:
Enter global configuration mode
ftp-client [vrf vrfname] ascii
Configure FTP to use text transfer mode
To configure the device to use BINARY transfer mode, execute the following commands in global configuration mode:
Enter global configuration mode
no ftp-client [vrf vrfname] ascii
Configure FTP to use binary transfer mode
To Next Page
Loading...
