Ruijie RG-S2900G-E Series - System Management Configuration

Configuration Guide System Management Display Configuration
System Management Configuration
CPU Utilization Display
Configuration Task List
 Show CPU utilization
 Configure CPU log limit threshold
Showing CPU Utilization
Use the show cpu command to show the total CPU utilization and the CPU utilization
per process:
Command
Function
Ruijie# show cpu
Show CPU utilization.
By default, the switch name is Ruijie.
Below is the result of executing this command:
Ruijie#show cpu
=======================================
CPU Using Rate Information
CPU utilization in five seconds: 25%
CPU utilization in one minute : 20%
CPU utilization in five minutes: 10%
NO 5Sec 1Min 5Min Process
0 0% 0% 0% LISR INT
1 7% 2% 1% HISR INT
2 0% 0% 0% ktimer
3 0% 0% 0% atimer
4 0% 0% 0% printk_task
5 0% 0% 0% waitqueue_process
6 0% 0% 0% tasklet_task
7 0% 0% 0% kevents
8 0% 0% 0% snmpd
9 0% 0% 0% snmp_trapd
10 0% 0% 0% mtdblock
11 0% 0% 0% gc_task
12 0% 0% 0% Context
13 0% 0% 0% kswapd
14 0% 0% 0% bdflush
15 0% 0% 0% kupdate