Ruijie RG-S2900G-E Series - Page 179

Configuration Guide MAC Address Configuration
Ruijie(config)#no mac-address-table filtering 00d0.f800.073c vlan 4
Viewing Configurations
Command
Function
Ruijie# show mac-address-table filtering
Show the information of all the
filtering MAC addresses.
The following example shows how to view the information of all the filtering
MAC addresses:
Vlan MAC Address Type Interface
---------- -------------------- -------- -------------------
4 00d0.f800.073c FILTER GigabitEthernet 0/3
Setting MAC Address Change
Notification
Setting MAC Address Change Notification
By default, the global switch of MAC addresses is turned off, so the MAC
address change notification function is disabled on all interfaces.
To configure the MAC address change notification function, execute the
following command:
Command
Function
Ruijie(config)# snmp-server host
host-addr traps [ version {1 | 2c |3 [auth |
noauth | priv]}] community-string
Configure the NMS to receive the
MAC address change notification.
host-add: IP address of the receiver.
version: Specify the version of the
SNMP Trap message to be sent.
community-string: Specify the
authentication name carried with the
SNMP Trap message.
Ruijie (config)#snmp-server enable traps
Allow the switch to send the SNMP
Trap message.
Ruijie(config)# mac-address-table
notification
Turn on the global switch of the MAC
address change notification function.