Ruijie RG-S2900G-E Series - Page 191

Configuration Guide Aggregate Port Configuration
Command
Function
destination IP addresses of the incoming packets.
src-dst-ip: Distribute traffic according to the
combination of the source IP addresses and
destination IP addresses of the incoming packets.
To restore the traffic balancing configuration of an AP to the default value,
execute the no aggregateport loag-balance command in the global
configuration mode:
Showing an Aggregate Port
In the privileged mode, show the AP configuration by performing the following
steps.
Command
Function
Ruijie# show aggregateport
[port-number]{load-balance |
summary}
Show the AP settings.
Ruijie# show aggregateport load-balance
Load-balance : Source MAC address
Ruijie# show aggregateport 1 summary
AggregatePort MaxPorts SwitchPort Mode Ports
------------- -------- ---------- ------
Ag1 8 Enabled ACCESS