Configuration Guide Voice VLAN Configuration
To set the working mode as manual mode, run the no form of this command.
For example:
# Enable auto mode on FastEthernet 0 / 1.
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-vlan)# voice vlan mode auto
Once voice VLAN is enabled, do not switch over auto mode and manual
mode on the port. If necessary, disable voice VLAN on the port first.
Under auto mode, adding or deleting a port to or from voice VLAN with
manual configuration mode is prohibited.
1) When voice VLAN is enabled and works in manual mode on a port, it is
necessary to manually add the port to voice VLAN to ensure the
effectiveness of voice VLAN.
2) In auto mode, do not set the native VLAN of a port as Voice VLAN for
normal operation.
3) For Ruijie products, all VLAN packets can be transmitted on Trunk Port /
Hybrid Port by default. Remove voice VLAN from the allowable VLAN list
of the port and then enable voice VLAN, ensuring that the port not
connecting voice device will not join Voice VLAN or the port unused for a
long time always locates in Voice VLAN.
Configuring Voice VLAN Aging Time
Subscribers may set Voice VLAN aging time on the equipment. When no voice
message is received from the input port within the aging time, the equipment
will delete the port from Voice VLAN. Only under auto mode does aging time
take effect.
To configure the aging time, run the following commands:
Ruijie# configure terminal
Enter global configuration mode.
Ruijie(config)# voice vlan aging minutes
Configure the aging time in the range
5-10000 minutes, 1440 minutes by default.
To restore the setting to the default value, run the no form of this command.
For example:
To Next Page
Loading...
