Ruijie RG-S2900G-E Series - Page 237

Configuration Guide Voice VLAN Configuration
Showing Voice VLAN Configuration and Status
Voice VLAN provides the following display command for showing various
configuration and operation information. Functions of each command is
explained as follows:
Command
Function
show voice vlan
Display Voice VLAN configuration information
and current status, including working modes of
ports enabling Voice VLAN function.
show voice vlan oui
Display OUI address, OUI address mask and
descriptive information which current equipment
supports.
show vlan
Display the working port of current Voice VLAN
with the same display command of general
VLAN.
1.4 Voice VLAN Configuration Example
Voice VLAN Auto Mode
Networking requirements
Suppose the configuration under Voice VLAN auto mode has following
requirements:
Create VLAN 2 as Voice VLAN.
Voice VLAN aging time is 1,000 minutes.
IP phones send tagged voice stream, and the input port is Trunk-type port Fa0/1
(It is an example here, and when using Voice VLAN function, please refer to
Table 2 Matching relationship between port mode and voice stream type of IP
phones‖ of Section Auto mode and manual mode of Voice VLAN. Native VLAN
of the port is VLAN 5.
The equipment allows voice messages with OUI address of ―0012.3400.0000‖
and mask code of "ffff.ff00.0000" being transmitted through Voice VLAN.
PC connected underneath with input port Fa 0/ 1 needs 802.1x authentication.