Ruijie RG-S2900G-E Series - Page 293

Configuration Guide Configuring Transparent Transmission of Protocol Frames
Command
Function
Ruijie# configure terminal
Enters the global configuration mode.
Ruijie(config)# bridge-frame forwarding protocol
cisco-pvst
Enables transparent transmission of Cisco’s PVST
frames.
Ruijie(config)# end
Returns to the privileged mode.
Configuration Example
Configuration Example
Networking topology
Figure 1-1. Simple configuration of transparent transmission of PVST frames
Configuration requirements
In this network topology, Ruijie switch is working with Cisco devices. Enable Cisco PVST on the Cisco
switches and the multicast function on the Ruijie switch. Make sure that Cisco PVST works properly.
Configuration procedure
Configure transparent transmission of PVST frames on the Ruijie switch.
SwitchA# configure terminal
SwitchA(config)# bridge-frame forwarding protocol cisco-pvst
SwitchA(config)# end