Configuration Guide Basic Switch Management Configuration
Viewing System Information and Version
System information consists of description, power-on time, hardware version,
software version, BOOT-layer software version, CTRL-layer software version,
and so on. System information helps you know the system You can show the
system information with the following commands in the privileged mode.
Viewing Hardware Entity Information
Hardware information refers to the information on physical devices as well as
slots and modules assembled in a device. The information on a device itself
includes description, number of slots,slot information, slot number, description
of the module on the slot (empty description if no module is plugged on the slot),
number of physical ports of the module on the slot, and maximum number of
ports possibly supported on the slot (number of ports of the module plugged).
You may use the following commands to show the information of the device and
slots in the privileged mode:
Ruijie# show version devices
Ruijie# show version slots
Show the information about slots and
modules.
Setting Console Rate
Overview
The switch comes with a console interface for management. When using the
switch for the first time, you need to execute configuration through the console
interface.You can change the console rate on the equipment if necessary. Note
that the rate of the terminal used to managing the switch must be the same as
that of the console interface on the switch.
Setting Console Rate
In the line configuration mode, execute the following command to set the
console rate:
To Next Page
Loading...
Need help?
General