Ruijie RG-S2900G-E Series - Page 318

Configuration Guide QinQ Configuration
Note
The addresses available for STP packet are 01d0f8 000005, 011a.a9 000005,
010f.e2 000003, 01000ccd.cdd0, 01000ccd.cdd1, 01000ccd.cdd2.
Without transparent transmission address configured, by default, the first three
bytes are 01d0f8, and the last three bytes of stp are 000005.
Showing QinQ Informaiton
In the privileged mode, use the following command to show QinQ configuration.
Command
Description
Ruijie# show dot1q-tunnel
Show the enablement state of dot1q-tunnel port.
Ruijie#show
interface[ intf-id ]dot1q-tunnel
Show the configuration of dot1q-tunnel port.
Ruijie# show registration-table
[ interface intf-id ]
Show the protocol-based VID change policy
table on the dot1q-tunnle port.
Ruijie# show translation-table
[ interface intf-id ]
Show the protocol-based VID change policy
table on the Access, Trunk and Hybird ports.
Ruijie# show traffic-redirect
[ interface intf-id ]
Show the flow-based VID change policy table.
Ruijie# show frame-tag tpid
interface [ intf-id ]
Show the TPID value on the interface.
Ruijie# show inner-priority-trust
Show the priority duplication configuration.
Ruijie# show interface intf-name
remark
Show the priority mapping configuration.
Ruijie# show
mac-address-mapping
Show the address duplication configuration.
Ruijie# show l2protocol-tunnel
stp
Show the transparent transmisison configuration
of Layer 2 protocols.