Ruijie RG-S2900G-E Series - Page 377

Configuration Guide DHCPv6 Configuration
The DHCPv6 client gets relevant parameters based on interface, such as Domain Name Server,
SNTP server. Relevant parameters configurations depend on the validity of interface.
Introduction to the DHCPv6 Relay
The DHCPv6 relay forwards DHCPv6 messages between the DHCPv6 server and the DHCP
client. When the DHCP server and the DHCP client are not in the same physical network, the
DHCP relay is responsible for forwarding the DHCP solicit and reply messages. The forwarding
process is different from routing forwarding, which features transparent transmission. Generally,
the router will not modify the contents of IP packets. Upon receiving the DHCP message, the
DHCP relay will regenerate and forward another one.
The DHCP relay is just like a DHCP server for the DHCP clients and a DHCP client for the
DHCP server.
DHCPv6 Configuration Task List
The DHCPv6 configuration tasks include:
 错误!未找到引用源。
 错误!未找到引用源。
 错误!未找到引用源。
 错误!未找到引用源。
 错误!未找到引用源。
Configure the DHCPv6 Client
This task involves how to enable DHCPv6 client function and prefix solicitation on the interface.
To configure the DHCPv6 Client, run the following commands:
Command
Function
Ruijie# configure terminal
Enter global configuration mode.
Ruijie (config)# interface type number
Enter interface configuration mode.
Ruijie (config-if)#ipv6 dhcp client pd
prefix-name [rapid-commit]
Enable the DHCPv6 client and prefix
solicitation on the interface.
For example:
Ruijie# configure terminal
Ruijie(config)# interface fastethernet 0/1
Ruijie(config-if)# ipv6 dhcp client pd pd_name