Ruijie(config)# no ip ref ecmp
load-balance {[crc32_lower | crc32
upper] [dip] [port] [udf number]}
Use the corresponding "no" command to
remove KEY components represented by the
keywords carried in "no" command.
For example, the combination of SIP+DIP+Port
has been saved by the system. After executing
"no ip ref ecmp route dip port" command, SIP
will be the only component of KEY. If the
components specified in "no" command are not
included in the configurations saved by the
system, no fault will arise by executing this
command.
To Next Page
Loading...
