Ruijie RG-S2900G-E Series - Page 438

Configuration Guide MLD Snooping Configuration
Ruijie# configure terminal
Ruijie(config)# ipv6 mld snooping vlan 1 mrouter interface gigabitEthernet 0/1
Ruijie(config)# ipv6 mld snooping vlan 1 mrouter learn
Ruijie(config)# end
Ruijie# show ipv6 mld snooping mrouter
VLAN Interface State MLD profile
---- --------- ------ -------------
1 GigabitEthernet 0/1 static 0
1 GigabitEthernet 0/2 dynamic 0
Ruijie# show ipv6 mld snooping mrouter learn
VLAN learn method
---- ------------------
1 pim
Product
support
As for Version 10.4, all products support this configuration.
Configuring Static Listener Port
Use this command to set a port joins to the IPv6 multicast group statically to become
a static listener port, if the host that connects to the port needs to receive the IPv6
multicast data sent to an IPv6 multicast group in a fixed manner.
To configure the MLD Snooping static listener port, run the following commands:
Command
Function
Ruijie(config)# ipv6 mld snooping
ivgl
Enable and set MLD Snooping to IVGL
mode.
Ruijie(config)# ipv6 mld snooping
vlan vlan-id static ip-addr interface
interface-id
Statically configure a port to receive
certain multicast stream.
• vlan-id: VID of multicast stream
• ip-addr: Multicast address
• interface-id:Port number