Ruijie RG-S2900G-E Series - Page 51

Configuration Guide LINE Mode Configuration
Command
Description
line vty line number
Enter the line configuration
mode.
transport input {all | ssh | telnet | none}
Configure the protocol to
communicate on the line.
no transport input
Disable the communication of
any protocol on the line.
default transport input
Restore the setting to the default
value.
Configuring the Access Control List on the Line
To configure the access control list on the line, you can use the command. By
default, no access control list is configured on the line.That is, all incoming and
outgoing connections are permitted.
Command
Description
configure terminal
Enter the configuration mode.
line vty line number
Enter the line configuration
mode.
access-class access-list-number {in | out}
Configure the access control list
on the line.
no access-class access-list-number {in | out}
Remove the configuration.