Ruijie RG-S2900G-E Series - Page 517

Configuration Guide 802.1x Configuration
In the privileged EXEC mode, you can set the packet sending interval by performing the following steps:
Command
Function
Ruijie(config)#dot1x auto-req req-interval interval
Setting the Packet Sending Interval
Ruijie#show dot1x auto-req
Show the configuration.
The no option of the command restores the value to its default. Since sending the authentication request multicast
message will cause re-authentication for all users under the authentication interface, the sending interval shall not be too
small lest the authentication efficiency is affected.
It is possible to set whether to stop sending the request messages when the user authentication passes. In some
applications (only one user under a port, for example), we can stop sending authentication requests to the related port
when the device finds the user authentication passes. If the user gets offline, the request is sent continually.
In the privileged EXEC mode, you can set this function by performing the following steps:
Command
Function
Ruijie(config)#dot1x auto-req user-detect
Stop sending the messages when there is some authentication
user under the port. This function is enabled by default.
Ruijie#show dot1x auto-req
Show the configuration.
The no option of the command disables the function. Before setting this function, take careful considerations on the
current network application environment.
The above three commands provide you with flexible application strategies. You can select the appropriate configuration
command according to the specific network application environment. To help you configure easily, the following
configuration table is provided for your reference:
Solution 1
Solution 2
Solution 3
User environment
One port for any user
One port for one user
One port for multiple users
Whether the Ruijie
supplicant should
be used as the
authentication
client
Yes
No
No
Configuration
command
recommended
Not necessary to enable the
dot1x auto-req function
dot1x auto-req
dot1x auto-req
packet-num num
dot1x auto-req
req-interval interval
dot1x auto-req
user-detect
dot1x auto-req
dot1x auto-req
packet-num 0
dot1x auto-req
req-interval interval
no dot1x
auto-req user-detect