Configuration Guide 802.1x Configuration
! Configure RADIUS server
Ruijie(config)#radius-server host 192.168.32.120
Ruijie(config)#radius-server host 192.168.32.121
! Configure RADIUS key
Ruijie(config)#radius-server key ruijie
! Configure server group (select active server and standby server)
Ruijie(config)#aaa group server radius rj
Ruijie(config-gs-radius)#server 192.168.32.120
Ruijie(config-gs-radius)#server 192.168.32.121
! Configure dot1x authentication list
Ruijie(config)#aaa authentication dot1x hello group radius
! Apply dot1x authentication method list
Ruijie(config)#dot1x authentication hello
! Configure 802.1X accounting method list
Ruijie(config)#aaa accounting network jizhang start-stop group radius
! Apply 802.1X accounting method list
Ruijie(config)#dot1x accounting jizhang
! Configure the port as controlled port (enable port-based authentication)
Ruijie(config)#interface range fastEthernet 0/1-22
Ruijie(config-if-range)#dot1x port-control auto
! Configure the control mode of user authentication under the corresponding port as port-based authentication
Ruijie(config-if-range)# dot1x port-control-mode port-based
Ruijie(config-if-range)#exit
! Configure to prohibit dynamic user from moving between ports;
Ruijie(config)#dot1x stationarity enable
! Configure IP authorization mode of device as RADIUS Server mode
Ruijie(config)#aaa authorization ip-auth-mode radius-server
! Configure the default route of device
Ruijie(config)#ip route 0.0.0.0 0.0.0.0 192.168.217.1
! Configure the IP address of device
Ruijie(config)#interface vlan 1
Ruijie(config-if-VLAN 1)#ip address 192.168.217.81 255.255.255.0
To Next Page
Loading...
