Configuration Guide SSH Terminal Service Configuration
As shown in Figure-1, protocol 2 is used for login, so SSH2 is chosen in
“Protocol”. “Hostname” indicates the IP address of the host that will log in,
192.168.5.245. Port 22 is the default number of the port for SSH listening.
“Username” indicates the username, and does not take effect when the device
only requires password. “Authentication” indicates the authentication mode, and
the username/password authentication is supported here. The used password
is the same as the Telnet password.
Click “OK” to pop up the following dialog:
Figure-2
Click “Connect” to log into the host just configured, as shown below:
Figure-3
To Next Page
Loading...
