Ruijie RG-S2900G-E Series - Page 634

Configuration Guide Port-based Flow Control Configuration
Ruijie(config-if)# arp-check
Enable arp check.
Ruijie(config-if)# no arp-check
Disable arp check.
Ruijie(config-if)#arp-check auto
Restore to the default configuration: enabled.
Showing the ARP Check Entry on the interface
Use the following commands to show the ARP check entry information on the interface:
Command
Actio
n
Ruijie#show interface
{ interface-type interface-number }
arp-check list
Show the ARP check entry information.
The example below shows the ARP check entry information:
Ruijie#show interfaces arp-check list
Interface Sender MAC Sender IP Policy Source
------------------------ ---------------- ---------------- --------------------
Gi 0/1 00D0.F800.0003 192.168.1.3 address-bind
Gi 0/1 00D0.F800.0001 192.168.1.1 port-security
Gi 0/4 192.168.1.3 port-security
Gi 0/5 00D0.F800.0003 192.168.1.3 address-bind
Gi 0/7 00D0.F800.0006 192.168.1.6 AAA ip-auth-mode
Gi 0/8 00D0.F800.0007 192.168.1.7 GSN