Ruijie RG-S2900G-E Series - Page 677

Configuration Guide DHCPv6 Snooping Configuration
To restore the setting to the default value, run the no ipv6 dhcp snooping binding-delay
command in the global configuration mode.
Configuration example:
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# ipv6 dhcp snooping binding-delay 10
Ruijie(config)# end
、
Showing/ Clearing DHCPv6 Snooping Configurations and States
The following commands show or clear DHCPv6 Snooping configurations and states.
Command
Function
show ipv6 dhcp snooping
Show DHCPv6 Snooping configuration.
show ipv6 dhcp snooping statistics
Show DHCPv6 Snooping statistics.
show ipv6 dhcp snooping binding
Show all dynamically bound entries of DHCPv6
Snooping binding database.
show ipv6 dhcp snooping prefix
Show all entries of the DHCPv6 Snooping prefix
database.
show ipv6 source binding
Show all manually added statically bound entries
and all dynamically bound entries of the DHCPv6
Snooping binding database.
clear ipv6 dhcp snooping statistics
Clear DHCPv6 Snooping statistics.
clear ipv6 dhcp snooping binding
Clear all dynamically bound entries of DHCPv6
Snooping binding database.
clear ipv6 dhcp snooping prefix
Clear all entries of the DHCPv6 Snooping prefix
database.