Ruijie RG-S2900G-E Series - Page 683

Configuration Guide NFPP Configuration
administrator can configure the packet percent. If the length of the queue for
one type of the packet is more than the total queue length multiplied by the
packet percent, the type of packets will be discarded.
Configuring NFPP
This section describes how to configure the NFPP.
 Default NFPP configuration.
 Configuring the packet traffic bandwidth.
 Configuring the packet percent.
 Anti-attack Protocols
Default NFPP Configuration
The default configurations of NFPP are as follows:
Packet type
Default traffic bandwidth
Default packet
percent
Manage
3000PPS
30
Route
3000PPS
25
Protocol
3000PPS
45
Configuring the packet traffic bandwidth
This section describes how to configure the packet traffic bandwidth:
Command
Function
Ruijie(config)# cpu-protect sub-interface
{manage|protocol|route} pps pps_vaule
Configure the traffic bandwidth
threshold of the corresponding packet,
in pps, ranging from 1 to 8192, in
integer.
For example:
Ruijie(config)# cpu-protect sub-interface manage pps 200
Ruijie(config)# end
Configuring the packet percent
This section describes how to configure the packet percent:
Command
Function