Ruijie RG-S2900G-E Series - Page 695

Configuration Guide NFPP Configuration
Clearing the ARP san table
The administrator can use the following command to clear the ARP scan table
manually.
Command
Function
Ruijie# clear nfpp arp-guard scan
Clear the ARP scan table.
Showing arp-guard
 Showing arp-guard configuration
 Showing monitored host configuration
 Showing arp scan table
Showing arp-guard configuration
Use this command to show the arp-guard configurations.
Command
Function
Ruijie# show nfpp arp-guard summary
Show the arp-guard configurations.
For example,
Ruijie# show nfpp arp-guard summary
（Format of column Rate-limit and Attack-threshold is per-src-ip/per-src-
mac/per-port.）
Interface Status Isolate-period Rate-limit Attack-threshold Scan-thresh
old
Global Enable 300 4/5/60 8/10/100 15
G 0/1 Enable 180 5/-/- 8/-/- -
G 0/2 Disable 200 4/5/60 8/10/100 20
Maximum count of monitored hosts: 1000
Monitor period：300s