Ruijie RG-S2900G-E Series - Page 697

Configuration Guide NFPP Configuration
Ruijie# show nfpp arp-guard hosts
If column 1 shows '*', it means "hardware do not isolate user" .
VLAN interface IP address MAC address remain-time(s)
---- -------- --------- ----------- -------------
1 Gi0/1 1.1.1.1 - 110
2 Gi0/2 1.1.2.1 - 61
*3 Gi0/3 - 0000.0000.1111 110
4 Gi0/4 - 0000.0000.2222 61
Total：4 hosts
Ruijie# show nfpp arp-guard hosts vlan 1 interface G 0/1 1.1.1.1
If column 1 shows '*', it means "hardware do not isolate user".
VLAN interface IP address MAC address remain-time(s)
---- -------- --------- ----------- -------------
1 Gi0/1 1.1.1.1 - 110
Total：1 host
Note
If the MAC address columm shows “-”, it means “the host is identified
by the source IP address”;
If the IP address columm shows “-”, it means “the host is identified by
the source MAC address”.
Showing the ARP scan table
Command
Function
Ruijie# show nfpp arp-guard scan
statistics
Show the arp-guard scan statistics.
Ruijie#show nfpp arp-guard scan [vlan
vid] [interface interface-id] [ip-address]
[mac-address]
Show the arp-guard scan information.
show nfpp arp-guard scan vlan vid:
Show the arp-guard scan information
in a VLAN.
show nfpp arp-guard scan [vlan
vid] [interface interface-id]: Show the
arp-guard scan information on a
interface in a VLAN.
show nfpp arp-guard scan [vlan
vid] [interface interface-id]
[ip-address] [mac-address]: Show the
arp-guard scan information for a MAC
address on a interface in a VLAN.