Ruijie RG-S2900G-E Series - Page 700

Configuration Guide NFPP Configuration
Command
Function
Ruijie# configure terminal
Enter the global configuration mode.
Ruijie(config)# nfpp
Enter the nfpp configuration mode.
Ruijie(config-nfpp)# ip-guard enable
Enable the ip-guard. By default, ip-guard
is enabled.
Ruijie(config-nfpp)# end
Return to the privileged EXEC mode.
Ruijie# configure terminal
Enter the global configuration mode.
Ruijie# interface interface-name
Enter the interface configuration mode.
Ruijie(config-if)# nfpp ip-guard enable
Enable the ip-guard on the interface. By
default, ip-guard is not enabled on the
interface.
Ruijie(config-if)# end
Return to the privileged EXEC mode.
Ruijie# show nfpp ip-guard summary
Show the configurations.
Ruijie# copy running-config
startup-config
Save the configurations.
Caution
With the ip-guard disabled, the monitored hosts are auto-cleared.
Configuring the isolated time
For the isolated time of the attacker, it can be configured in the global or
interface configuration mode. By default, the isolated time is configured in the
global configuration mode.
Command
Function
Ruijie# configure terminal
Enter the global configuration mode.
Ruijie(config)# nfpp
Enter the nfpp configuration mode.
Ruijie(config-nfpp)# ip-guard
isolate-period [seconds | permanent]
Configure the global isolated time,
ranging 0s, 30-86400s(one day). The
default value is 0s, representing no
isolation. Permanent represents
permanent isolation.