Ruijie RG-S2900G-E Series - Page 722

Configuration Guide NFPP Configuration
Command
Function
Ruijie# clear nfpp icmp-guard hosts [vlan
vid] [interface interface-id] [ip-address]
clear nfpp icmp-guard hosts: Clear
all isolated hosts.
clear nfpp icmp-guard hosts vlan
vid: Clear all isolated hosts in a
VLAN.
clear nfpp icmp-guard hosts [vlan
vid] [interface interface-id]: Clear all
isolated hosts on a interface in a
VLAN.
clear nfpp icmp-guard hosts [vlan
vid] [interface interface-id]
[ip-address]: An isolated host has
been cleared. Use the IP address to
identify the hosts.
Showing icmp-guard
 Showing icmp-guard configuration
 Showing monitored host configuration
 Showing trusted host configuration
Showing icmp-guard configuration
Use this command to show the icmp-guard configurations.
Command
Function
Ruijie# show nfpp icmp-guard summary
Show the icmp-guard configurations.
For example,
Ruijie# show nfpp icmp-guard summary
（Format of column Rate-limit and Attack-threshold is per-src-ip/per-src-
mac/per-port.）
Interface Status Isolate-period Rate-limit Attack-threshold
Global Enable 300 4/-/60 8/-/100
G 0/1 Enable 180 5/-/- 8/-/-
G 0/2 Disable 200 4/-/60 8/-/100
Maximum count of monitored hosts: 1000
Monitor period：300s