Ruijie RG-S2900G-E Series - Page 748

Configuration Guide NFPP Configuration
Command
Function
Ruijie(config-nfpp)# end
Return to the privileged EXEC mode.
Ruijie# configure terminal
Enter the global configuration mode.
Ruijie(config)# interface
interface-name
Enter the interface configuration mode.
Ruijie(config-if)# nfpp nd-guard policy
per-port [ns-na | rs | ra-redirect]
rate-limit-pps attack-threshold-pps
Configure the rate-limit and attack threshold
on the specified interface.
rate-limit-pps: set the rate-limit threshold.
The valid range is 1-9999.
attack-threshold-pps: set the attack
threshold. The valid range is 1-9999.
Ruijie(config-nfpp)# end
Return to the privileged EXEC mode.
Ruijie(config-if)# show nfpp nd-guard
summary
Show the parameter settings.
Ruijie# copy running-config
startup-config
Save the configurations.
Showing dhcpv6-guard
 Showing ND-guard configuration
Showing ND-guard configuration
Use this command to show the ND-guard configurations.
Command
Function
Ruijie# show nfpp nd-guard summary
Show the ND-guard configurations.
For example,
Ruijie# show nfpp nd-guard summary
（Format of column Rate-limit and Attack-threshold is NS-NA/RS/RA-REDIRECT.）
Interface Status Rate-limit Attack-threshold
Global Enable 20/5/10 40/10/20
G 0/1 Enable 15/15/15 30/30/30
G 0/2 Disable -/5/30 -/10/50