Ruijie RG-S2900G-E Series - Page 755

Configuration Guide Ruijie Switches Security Compatible Mode Configuration
two modes : RGOS compatible mode and non-RGOS compatible mode. By
default, they coexist in RGOS compatible mode.
Operation Principles of Ruijie Switches Security Compatible Mode
Ruijie Switches security functions coexist in two modes-RGOS compatible
mode and non-RGOS compatible mode. By default, RGOS compatible mode is
used. To enable the non-RGOS compatible mode, run the no rgos-security
compatible command, save configuration and then restart. On the contrary, to
enable the RGOS compatible mode, run the rgos-security compatible command,
save configuration and then restart.
Protocol Specifications
None
Default Configuration of Security Compatible Mode
Below is the default configuration of security compatible mode.
Function
Default value
Coexistence in RGOS compatible mode
Enabled
Configure the Security Compatible Mode
Command
By default, Ruijie Switches’ security functions coexist in RGOS compatible
mode. To set the coexistence mode of security function, do the following steps:
Command
Function
Ruijie# configure terminal
Enters the global
configuration mode.
Ruijie(config)#rgos-security compatible
Sets the coexistence mode to
RGOS compatible mode.
Ruijie(config)# exit
Exits the global configuration
mode.
Note
In 10.4 version, the function is supported on all products.