Configuration Guide SNMP Configuration
Ruijie(config)# snmp-server location fuzhou
Ruijie(config)# snmp-server contact wugb@i-net.com.cn
Ruijie(config)# snmp-server chassis-id 1234567890
0987654321
The following configuration is optional; the router is allowed to send some Trap
messages to the NMS proactively.
Ruijie(config)# snmp-server enable traps
Ruijie(config)# snmp-server host 192.168.12.181 public
The SNMP agent is configured for the router by the above configuration. Then,
the NMS can monitor and manage the router. Take HP OpenView as an
example and a network topology is coming into being as follows:
Network topology diagram
Now it is possible to query or set the management units in the network device.
Click the TOOL->SNMP MIB Brower menu on the HP OpenView to display the
following dialog box. Enter the IP address 192.168.12.1 in the Name field and
"public" in the Community Name field. Select the specific management unit of
the MIB, such as the "system" in the diagram below. Click Start Query to initiate
MIB query for the network device. The results are displayed in the MIB Values
pane of the dialog box.
To Next Page
Loading...
