Configuration Guide NTP Configuration
root dispersion is 0.00003 msec, peer dispersion is 0.00003 msec
The starum indicates the level of current clock, reference indicates
the address of the server used for synchronization, freq indicates
the clock frequency of current system, precision indicates the
precision of current system clock, reference time indicates the
UTC time of reference clock on the synchronization server, clock
offset indicates the offset of current clock, root delay indicates the
delay of current clock, root dispersion indicates the precision of
top server, peer dispersion indicates the precision of
synchronization server.
Configuration Examples
In the following configuration, there is an NTP server specified as the master in
the network, relevant authentication mechanism is enabled, a key with the
key-id of 6 and the key-string of wooooop is configured as the trusted key for
the server. To configure the Ruijie client to synchronize the time with the NTP
server on the network, configure the NTP client as follows: enable security
authentication, configure the same key as that for the NTP server, set this NTP
server to synchronize the time, and begin to synchronize the time.
The IPv4 configuration example:
Ruijie(config)# no ntp
Ruijie(config)# ntp authentication-key 6 md5 wooooop
Ruijie(config)# ntp authenticate
Ruijie(config)# ntp trusted-key 6
Ruijie(config)# ntp server 192.168.210.222 key 6
Ruijie(config)# interface gigabitEthernet 0/1
Ruijie(config-if)# ntp disable
Ruijie(config-if)# no ntp disable
To Next Page
Loading...
