Configuration Guide SNTP Configuration
Configuring the Local Time-zone
The time obtained through the SNTP communication is Greenwich Mean
Time(GMT). In order to obtain the exact local time, you need to set the local
time to adjust the mean time.
To configure the local time-zone, run the following commands in the interface
configuration model:
Ruijie(config)#clock time-zone time-zone
Configure the time-zone, ranging from
GMT-23 to GMT+23, wherein ―-‖
indicates western area, ―+‖ indicates
eastern area and ―0‖ indicates
Greenwich mean time. The default
time-zone is GMT+8, Beijing time.
To restore the local time-zone to the default, use the command no clock
time-zone.
Showing SNTP Information
Execute the show sntp command in the privileged mode to show the current
SNTP information.
Ruijie# show sntp
SNTP state : ENABLE //to view whether SNTP is enabled
or not
SNTP server : 192.168.4.12 //NTP Server
SNTP sync interval : 60 //SNTP sync interval
Time zone : +8 //Local Time-zone
To Next Page
Loading...
