Configuration Guide RSPAN Configuration
The table below presents ports that participate mirroring on the switch:
Monitored user port that copies UDP to the
designated output port or the reflector port via
local port mirroring. There are many source
ports.
Used for one-to-many mirroring. The packets
from the mirrored source port are reflected
through the reflector port and then outputted
through the output port. The reflector port
cannot forward traffic. It is recommended to
set the port in down state to be reflector port
and disable any configuration on it.
Send mirrored packets to the middle switch or
the destination switch.
Send mirrored packets to the destination
switch.
It is recommended to configure two Trunk
ports on the middle switch to connect the
devices on both sides.
Receive remote mirrored packets.
Monitoring port of remote mirrored packets.
A special VLAN, Remote VLAN is defined for remote port mirroring. The Remote
VLAN transmits only mirrored packet rather than bearing normal services. All
mirrored packets are transmitted from the source swithc through the Remote VLAN
to the designated port of the destination switch. Hence, you can monitor the packets
of the source switch on the destination switch.
To Next Page
Loading...
