Configuration Guide Web-based Configuration
Figure 1-17 IGMP Snooping setting
Configuration description:
To enable the IGMP Snooping function, Click the Enable option button and then the Mode
drop-down list changes to the selectable state. You can select three modes: ivgl, svgl, or
ivgl-svgl from this list. If you select the mode svgl or ivgl-svgl, then you can set the parameters
such as identification and the range of the IP addresses. After the parameters are configured,
click Save to validate the configuration. To disable the IGMP Snooping function, Click the
Disable option button and click Save to validate the configuration.
STP Setting
Use the function through the menu item STP Setting .
The following is the main page of STP Setting.
Figure 1-18 STP setting
Configuration Description:
To Next Page
Loading...
