Remove the wash station nozzle and clean each part using neutral detergent. Since this is a wash station,
the nozzle need not be wiped down. However, preform a water supply test after installing the nozzle and
setting the solution reservoir, to confirm that the wash station nozzle has been connected correctly.
Refer to P. 1-13 for the installation/removal of the wash station nozzle, or P. 1-42 for the water supply test.
If the drain hose at the back of the stainer is clogged, staining may be affected and unwanted problems
may result. To prevent such problems, clean the drain hose at least once a month. Remove the drain hose
from the drain elbow and clean the inside of the hose using tap water. If the hose is still clogged after the
cleaning or is cracked and leaking water, etc., replace the hose with a new one. Refer to P. 1-10 for the
installation method of the drain hose.
If you have any question regarding cleaning, contact the Sakura Finetek Technical Support representative
or local representative.
To Next Page
Loading...
Need help?
General
